Ellis
February 12, 2022, 5:21pm
1
Can’t I add my flash drive to windows 10
noti2p
February 13, 2022, 12:59pm
2
Qube settings: add the hardware USB…bla…bla to the VM
Click on the hardware after APLY and No Strict Reset for that hardware. You might need to reboot. It is obviously risky because Windows (known offender can access Dom 0).
1 Like
Ellis
February 13, 2022, 4:35pm
4
Should it be in devices >>>> Available ?
enmus
February 13, 2022, 5:23pm
5
These would be the most helpful topic regarding Windows and USB
It is now available to test ability to attach USB devices to Windows. It works without QWT installation via QEMU emulation. To get it works make this steps:
update with current-testing repos
sudo qubes-dom0-update --enablerepo=qubes-dom0-current-testing
install advanced variant linux stubdomain (now available only in current-testing repos):
sudo qubes-dom0-update --enablerepo=qubes-dom0-current-testing xen-hvm-stubdom-linux-full
update and restart sys-usb with current-testing repos too
ena…
Hello,
Yesterday I tried to implement :
Unfortunately I noticed I was not on 4.1 but instead 4.0.
The problem is that after following the instructions :
[image]
Now I cannot anymore connect any USB to any of my VM…
It says it’s connected on the Qubes Devices but I cannot access them inside my VM
Anyone know how to fix this?
Thank you in advance
But probably upgrading to 4.1 would be the best prerequisite.
Ellis
February 17, 2022, 8:04pm
6
The same problem Can’t add USB
It is now available to test ability to attach USB devices to Windows. It works without QWT installation via QEMU emulation. To get it works make this steps:
update with current-testing repos
sudo qubes-dom0-update --enablerepo=qubes-dom0-current-testing
install advanced variant linux stubdomain (now available only in current-testing repos):
sudo qubes-dom0-update --enablerepo=qubes-dom0-current-testing xen-hvm-stubdom-linux-full
update and restart sys-usb with current-testing repos too
ena…
enmus
February 17, 2022, 8:17pm
7