Hi,
I’ve just upgraded my 3 years old ntb to qubes 4.1.1 from 4.0.3. Everything went fine, no workarounds were necessary - downloaded fresh iso & dd → usb, booted to GUI and installed without problems.
The only problem was that after reboot there was no qubes in bootloader and system jumped to HW check. I enabled legacy boot mode in bios and reinstalled - same result. Then I turned off legacy mode and did the reinstall again, but now qubes booted from disk.
A bit strange, however it worked.
Then I restored my backup - all restored machines successfully started.
So far I see no complications - sound, graphics, second display over hdmi, wifi, usb-eth adapter, I see all devices in sys-usb. I’m quite impressed and praise qubes team for good job.
I found similar [qubes-users] HCL - Dell XPS 9570, but I did not find button to add this review there, so feel free to move it if necessary.
Here is my yml:
---
layout:
'hcl'
type:
'notebook'
hvm:
'yes'
iommu:
'yes'
slat:
'yes'
tpm:
'unknown'
remap:
'yes'
brand: |
Dell Inc.
model: |
XPS 15 9570
bios: |
1.5.0
cpu: |
Intel(R) Core(TM) i9-8950HK CPU @ 2.90GHz
cpu-short: |
FIXME
chipset: |
Intel Corporation 8th Gen Core Processor Host Bridge/DRAM Registers [8086:3ec4] (rev 07)
chipset-short: |
FIXME
gpu: |
Intel Corporation CoffeeLake-H GT2 [UHD Graphics 630] [8086:3e9b] (prog-if 00 [VGA controller])
gpu-short: |
FIXME
network: |
Qualcomm Atheros QCA6174 802.11ac Wireless Network Adapter (rev 32)
memory: |
32407
scsi: |
usb: |
1
versions:
- works:
'FIXME:yes|no|partial'
qubes: |
R4.1
xen: |
4.14.5
kernel: |
5.15.64-1
remark: |
FIXME
credit: |
FIXAUTHOR
link: |
FIXLINK
---
Regards and thank you. 